AdvancedHMI Software
General Category => Support Questions => Topic started by: gofito1984 on September 22, 2017, 02:44:18 PM
-
Hello.
In version 399f, with Visual Studio, when I compiled a application with target "Any CPU" and I executed the application in a 64 bits PC, the application crashed.
Now, with version 399x, a compiled application with target "Any CPU" works fine in a 64 bits PC.
Did you fix this issue?
Good Job!
-
Were you preview using the OpcDaCom driver? That is the only component that requires 32 bit compilation.
-
It is the same application. I updated the version of Advanced HMI.
-
It must have just been a coincidental side effect of another change. To my knowledge there has been no direct changes done to affect the target CPU type.