AdvancedHMI Software

General Category => Open Discussion => Topic started by: larryhts on September 25, 2018, 08:05:54 AM

Title: AutomationDirect Ethernet/IP to Allen Bradley L306ER
Post by: larryhts on September 25, 2018, 08:05:54 AM

Archie,  I have a (5069-L306ER) talking Ethernet/IP to a (P2_-550) Using the example in the P2-550 help file section “Ethernet/IP for the Productivity Series” Set the Ethernet/IP Adapter in the P2 just like the example. Added a Generic Ethernet Module in the AB PLC  data type as INT.  50 elements.  AB 0-49 – P2 1-50.  AB writes to output block and reads input block ,  P2 write to  input block and reads output block. Thanks

Title: Re: AutomationDirect Ethernet/IP to Allen Bradley L306ER
Post by: Archie on September 25, 2018, 08:19:34 AM

Nice. Sounds like it was fairly easy to get it going.

Title: Re: AutomationDirect Ethernet/IP to Allen Bradley L306ER
Post by: larryhts on September 25, 2018, 08:27:47 AM

Yes very just followed the example. Just have to remember the address offset AB 0-49 P2 1-50. Works well.