AdvancedHMI Software
General Category => Open Discussion => Topic started by: ndzied1 on October 09, 2013, 06:16:17 PM
-
Hello,
It seems that the Hydraulic Cylinder controls shows the cylinder rod as only fully extended or retracted.
Is there a way to get it to go to a certain position based on a value?
Thanks,
Norm
-
This one has been in the back of my mind for a while, but I never had a need for it or never had any request it until now. The changes have been started. Once I get an opportunity I'll finish converting it to an analog control. I'll see if I can make this available for the next release of 3.60
-
That is great news! Thanks.