AdvancedHMI Software

General Category => Support Questions => Topic started by: Intelect on March 09, 2013, 12:21:43 AM

Title: Win 7 VS 2012 Express
Post by: Intelect on March 09, 2013, 12:21:43 AM

Hi

I've had a quick read through the PLC.net forum and haven't found this issue covered.
When openning Advanced HMI all I'm getting is a Black screen.
I'll also note I'm inexperienced when I comes to Visual Studio

Cheers Jason

Title: Re: Win 7 VS 2012 Express
Post by: Archie on March 09, 2013, 01:08:41 AM

Are you able to build the solution and get items in the Toolbox?

Title: Re: Win 7 VS 2012 Express
Post by: Intelect on March 09, 2013, 03:11:57 AM

I was following the "Quick Start" steps and problem is at step 6 Build Advanced HMI
After building the Advanced HMI solution file all i get is a New window with AdvanceHMI at the top the window is full screen and black.

Thanks for the reply I'm just trying to have a play and see whats out there.

Cheers

Title: Re: Win 7 VS 2012 Express
Post by: Intelect on March 09, 2013, 05:54:56 AM

All good just Noob fault all sorted now thanks for your time

Title: Re: Win 7 VS 2012 Express
Post by: dmroeder on March 09, 2013, 04:54:18 PM

Intelect, you should share your solution with the forum just in case other users run into the same problem.

Title: Re: Win 7 VS 2012 Express
Post by: Intelect on March 09, 2013, 05:55:21 PM

Basically the Toolbox wasn't open when I open the solution file and didn't realise it was a Visual Studio window was expecting to open when I Build the solution like I said to Newbe issue. And the black screen was me actually running the HMI program with nothing on the window.