AdvancedHMI Software

General Category => Open Discussion => Topic started by: muratguenduez on June 11, 2018, 04:02:40 AM

Title: 3.99x modbus tcp timeout setting doesnt work ?
Post by: muratguenduez on June 11, 2018, 04:02:40 AM

hi bosses,
i have use gprs modem to connect a plc that i used before. i need to increase the timeout for the modbusTCP connection due to carrier issues. default is 3000 and i put it as 20000 but i see the connection error message on basicLabel in 3 second after runing the program!
i think this message should be seen after 20 seconds. why it is still 3 sec ?

or maybe i need to use another technic that i dont know =)

thanks

Title: Re: 3.99x modbus tcp timeout setting doesnt work ?
Post by: abdala on June 17, 2018, 12:09:06 PM

The problem is still there and the writing problem is slow