AdvancedHMI Software
General Category => Support Questions => Topic started by: Volare76 on July 25, 2013, 04:26:54 PM
-
I have a DisplayMessageByBit component on a form that shows the machine status. The issue that I am having is the component will only display the first 3 messages out of 7. I have it on its own dedicated driver as I thought it might have been a conflict with the other controls, but that did not help. Any idea's?
-
In Design Mode, select the MessageDisplayByBit, then go to the properties and put the values 0,1,2,4,8,16.32,64,128 one at a time and see if it shows your messages.
Also when you go to the Messages windows, are all of your bit numbers consecutive 0,1,2,3,4,5,6,7
-
Apparently I messed up the bit numbers. When I checked I must have been looking at the index numbers not the bit number. Thank you.