AdvancedHMI Software
General Category => Support Questions => Topic started by: gusterminator on August 28, 2017, 02:56:43 PM
-
Hi,
I have a PID operating a HLT in RSLogix 5000.
I am able to get the PV value on the Temperature Controller graphics to update and the SP.
I would like to have the buttons on the Temperature Controller graphics increase the SP by 5 every time they are clicked The up arrow increase and the down arrow decrease.
Does any body know how I would go about doing this?
Thanks,
Gus
-
You will need to create 2 tags in your PLC and add 2 rungs of logic to add and subtract. Then put the tag names in PLCAddressClick3 and PLCAddressClick4.
Be sure to use one-shots in your rungs so it only changes once per press.
-
Hi,
Thanks for the reply. I put a one shot in the rung and nothing happens. If I remove the one shot it adds rapidly. I named the one shot the same as the Bit I'm using to trigger the Add 5 rung.
I'll do some reading on use of the one shot. I have used them before but I may be missing something.
-
I figured it out......I was using the Tag to enable the count 5 as my one shot......I created a new tag for the one shot and everything works......Thanks again.