Show Posts
1
Support Questions / Re: Error Code 192
« on: November 19, 2017, 12:33:26 AM »
Hi Gacore
The "Error Code 192" Displayed is generated by the NX1P! It is output to the HMI when the NX1P has a Minor Fault with the system eg lost communications to the Slices, If you Wire shark the Communications you will see the FINS Abort code "040" as the response for the NX1P to The HMI.
Advance HMI sees this as a total Communications Fault and Drops all of the Data.. (Yes Lost Communications to the Slices is considered a Minor Fault in the NX1P) ??
Once you get all fault within the NX1P solved this error will go.
The "Error Code 192" Displayed is generated by the NX1P! It is output to the HMI when the NX1P has a Minor Fault with the system eg lost communications to the Slices, If you Wire shark the Communications you will see the FINS Abort code "040" as the response for the NX1P to The HMI.
Advance HMI sees this as a total Communications Fault and Drops all of the Data.. (Yes Lost Communications to the Slices is considered a Minor Fault in the NX1P) ??
Once you get all fault within the NX1P solved this error will go.