1
Open Discussion / Stepper motor
« on: September 01, 2017, 12:15:47 PM »
Hey guys,
We have a stepper motor with advanced driver from Automation direct.
Can someone tell me if it's possible, (and point me in the right direction on how to) communicate with the driver via serial command from Adv hmi?
Eg. In the host window, "VE(XX)cr" sets the velocity, how would I go about setting it up so I could enter that on the HMI screen and send to the driver?
We have a stepper motor with advanced driver from Automation direct.
Can someone tell me if it's possible, (and point me in the right direction on how to) communicate with the driver via serial command from Adv hmi?
Eg. In the host window, "VE(XX)cr" sets the velocity, how would I go about setting it up so I could enter that on the HMI screen and send to the driver?