AdvancedHMI Software

General Category => Support Questions => Topic started by: Programmer81 on May 20, 2014, 12:48:09 PM

Title: Saving Multiple HMI Programs to ONE computer
Post by: Programmer81 on May 20, 2014, 12:48:09 PM

I have run into an issue.  I cannot seem to save and run multiple HMI programs to one computer.  Has anyone else run into this problem?  I have no issue creating an executable, but I can't have multiple executable files done in AdvancedHMI and run them on the same computer.  My issue is that I'm actually trending data from this software and saving to a CSV file on my server.  I would like to run multiple programs I write in this wonderful piece of software on one computer. 

Any advice?

Title: Re: Saving Multiple HMI Programs to ONE computer
Post by: dmroeder on May 20, 2014, 02:02:16 PM

I think "make single instance" is checked by default which would only allow you to run one instance at a time.  Try un-checking it:

Go to Project > AdvancedHMI Properties > Uncheck "Make single instance application".