AdvancedHMI Software

General Category => Open Discussion => Topic started by: blueskies on October 29, 2013, 02:46:31 AM

Title: Not able to read R6:0 registers on SLC?
Post by: blueskies on October 29, 2013, 02:46:31 AM

I am trying to read a R6:0 value. R6:0.POS , but it just comes back as invalid address? I am using basic label.
Is there something I am missing?

Title: Re: Not able to read R6:0 registers on SLC?
Post by: Jesse on November 14, 2013, 04:39:38 PM

Try a MOV instruction, move the value for your position into an N file and then read that value in your HMI

Title: Re: Not able to read R6:0 registers on SLC?
Post by: blueskies on November 17, 2013, 12:29:00 AM

That's what I had done. Thanks

Also, Archie did fix this in 3.60.