AdvancedHMI Software
General Category => Open Discussion => Topic started by: Gene T. on October 19, 2022, 01:17:49 PM
-
I have a tag that I am wanting to trend.
I have this tag N59[39] assigned to a AnalogValueDisplay and it works with no issues.
If I add the same address to the PLCAddress section for the chart I get nothing. The chart doesn't not even start
at all. If I remove the [39] the chart will start but obviously not displaying the data that I want. I feel sure that I must
beover looking something but I just can't seem to figure this out.