AdvancedHMI Software
General Category => Support Questions => Topic started by: Michal_dk on November 12, 2015, 08:14:21 AM
-
Hi All!
I developed a HMI a couple of years ago and it has been running flawlesly since.
Now the complete exebition stand has vanished during transport from Denmark to Germany :-(
I am setting up a new PC and will travel to Germany to set up the new system. Since there have been no changes I just copied the project to a USB stick and moved it to the new PC. Now I guess my problem came because I double clicked the Setup file on the USB stick, instead of moving it the the harddrive first. It ran without any problems, but now I have moved the project to the harddrive and when I try to start (using the Setup file again) I get the following error message:
"you cannot start application advancedHMI from this location because it is already installed from another location"
The new PC is running Win7 Proff. 64 bit and is a MSI mini PC and I'm using v3.6.1 of AdvancedHMI
What went wrong? And how can I fix it?
Thanks,
Michal
-
OK, figured it out :-)
It apparently installes on the PC - has that always been the case?
Anyhow! Controlpanel - uninstall AdvancedHMI and I was able to run the setup from its new location :-)
-
This is one of the many quirks of using Publish, hence another reason I encourage just copying the solution directly instead of using Publish.