Show Posts
1
Support Questions / Click PLC Floating point addressing problem
« on: January 07, 2016, 10:15:15 PM »
Hello,
I have connected my Click PLC to the AHMI and can read / write to everything I need to except floating point addresses.
I have tried to word swap, byte swap and both to no avail..
I can write to an address (i.e. 428691) and it changes the number, but not to the number I entered.
I am assuming I have not configured something correctly, but I can't figure out my mistake.
Any help would be appreciated
Thank you,
Dean
I have connected my Click PLC to the AHMI and can read / write to everything I need to except floating point addresses.
I have tried to word swap, byte swap and both to no avail..
I can write to an address (i.e. 428691) and it changes the number, but not to the number I entered.
I am assuming I have not configured something correctly, but I can't figure out my mistake.
Any help would be appreciated
Thank you,
Dean