AdvancedHMI Software

General Category => Feature Request => Topic started by: boldive on October 23, 2018, 11:57:53 AM

Title: Libnodave, S7.Net support
Post by: boldive on October 23, 2018, 11:57:53 AM

Hello everyone.

This question is in the air for a while. So far there is no Siemens support in AdvancedHMI.
If Libnodave or S7.Net communication libraries are available, what is the chance to integrate them into AdvancedHMI?

Thanks

Title: Re: Libnodave, S7.Net support
Post by: Archie on October 23, 2018, 12:09:57 PM

An adaptation layer (wrapper) could be written, but it will be quite involved. The interface used for AdvancedHMI drivers is a fair amount different than those used in S7.NET and libnodave, especially the subscription mechanism which is rather complex.

Title: Re: Libnodave, S7.Net support
Post by: Noe on October 24, 2018, 02:10:50 PM

Quote from: boldive on October 23, 2018, 11:57:53 AM

Hello everyone.

This question is in the air for a while. So far there is no Siemens support in AdvancedHMI.
If Libnodave or S7.Net communication libraries are available, what is the chance to integrate them into AdvancedHMI?

Thanks

I know is not the same, but I use Modbus TCP to communicate AdvancedHMI with Siemens.

Title: Re: Libnodave, S7.Net support
Post by: DadFamad on September 19, 2019, 06:03:30 AM

Do you have a way to do about these things?