AdvancedHMI Software
General Category => Additional Components => Topic started by: Godra on April 10, 2020, 01:09:04 AM
-
As for the fan control that has both CW and CCW direction, you could try using the attached control.
The direction is controlled with PLCAddressDirection and the fan is turned on/off with the PLCAddressValue.
See the description attached to these properties.
-
Godra
Is it possible to change the colour of the fan from green to red, I would like to indicate if the fan has a fault.
-
The simple answer is No (this is a built-in control which I don't have access to).
If you do have a bit that indicates the fault then put a red LED control above the fan and point the address to that bit.
-
You can use a graphic indicator and load your own images. If you have access to symbol factory you can save different images with different colors. FTView ME has symbol factory. I had a control somewhere that had more than a few states, but I can't find it.