AdvancedHMI Software
General Category => Support Questions => Topic started by: sunny on February 11, 2015, 03:34:34 PM
-
Hi All
I am working on a project with a omron PLC. It is a CPM1 and I am using the OmronSerialHostLinkCom1 driver.
I use 2 DM words for the inputs. If I use 2 Annunciators to view for exaple D0.00 and D0.01 and turn only D0.00 true, than both of them light up. But on the label I put in to read the whole D0 word I see the correct value. And I can only read one word. If I put another annunciator on the mainform that reads D1.00 it wil do nothing. Unless I delete the first two annunciators.
When I want to wright it is pretty much the same thing. If I put two BasicButtons on the mainform and try to wright to D2.00 and D2.01. I can only see that D2.00 is doing something.
Something else the SelectorSwitch don't turn when I push it. But it sents the value to the PLC.
I hope someone can help me
Greetings Marcel
-
This is a known issue and was fixed on the Ethernet driver. It will be fixed in the serial driver for the next release.
-
thanks for the quick reply. Can you tell me when you think the new release is going to be released?
greetings marcel
-
I don't really have a good time frame. The TwinCAT driver and the DF1Com are being redone, so it will be after that is complete. My best guess is by the end of the month,
-
Hi Archie
I finaly went on with testing with te omron hostlink driver. I am using AdvancedHMI v3.98f but I have pretty much te same problems as in my first post. Although I can read a analoge value with a digitalpanelmeter. I hope you are able to help me.
Greetings Marcel
-
Some work was done with v3.98g to address this. Try it to see if it works.
-
Hi Archie
Thanks for all the work. I will try it during next week. (if I can find the time somewhere).
Greetings Marcel