AdvancedHMI Software

General Category => Support Questions => Topic started by: andreaboschetti71 on March 24, 2015, 07:58:49 AM

Title: DF1Comm and 3.98b
Post by: andreaboschetti71 on March 24, 2015, 07:58:49 AM

I have an old 3.60 HMI that uses DFCOM1 driver. Now I tried to change it to new 3.98b version. I made all the change that new version wants but hen I run it nothing updates. Seems that there's not communication between HMI and PLC but I didn't make any change.
Any suggestion?
thank you

Title: Re: DF1Comm and 3.98b
Post by: Archie on March 24, 2015, 08:27:59 AM

The DF1 driver was largely rewritten in the latest version and some of the functionality has not been fully restored yet. One of those is the AUTO baud rate. If you have it set to AUTO, try to manually put in all of the communication settings to see if it works.

Title: Re: DF1Comm and 3.98b
Post by: andreaboschetti71 on March 24, 2015, 11:03:25 AM

Yes, was that. Now it's ok. thanks