Messages

1

Support Questions / Re: Merging solutions

« on: January 17, 2019, 02:13:42 PM »

Thanks Archie!
This worked.

My issue wasn't renaming it, as I figured this was a problem so I had already tried that route.  My issue was that I manually selected all 3 files instead of just the VS file. 
I guess Visual Studio is much smarted than me;)

2

Support Questions / Merging solutions

« on: January 17, 2019, 01:09:40 PM »

This might be a silly question, but I have developed 2 different screens on 2 different instances of Advanced HMI and would like to somehow merge them to limit the need to rebuild them in the "master" project.
I was hoping a simple copy/paste of the "mainform.vb" class would do it, but that doesn't work.
I tried adding from existing as was suggested on an older post, but this does not import the [Design] part of it.

I know this is a noob issue, but I don't want to reinvent the wheel if there's a simple way of doing this.


Thanks in advance!

ha... I just realized I said advance

3

Support Questions / Re: Trackbar

« on: October 13, 2018, 03:30:18 PM »

Thank you so much
This worked like a charm!

4

Open Discussion / gtracker slider for setpoint control

« on: October 13, 2018, 12:29:23 AM »

Hi all!  I'm new to this software so please bare with me.
I have tried to install the gtrackbar as stated in an older post and it seems to have installed and I can configure a slider (trackbar) on the form however there is no option for PLC coms in the property section.  Am I missing something?
All other AdvancedHMI components include a PLC Communications option.

My goal is to be able to use this rather than operator entry for a 0-100% motor speed setting.  I know I can always use an up/down button setup but I feel this is sloppy and the slider seems to work well... I just can't set it up to talk to my PLC.
Also noteworthy is that other components built in to AdvancedHMI work fine and communicate very well.

Please help

5

Support Questions / Re: Trackbar

« on: October 13, 2018, 12:23:41 AM »

Hi all!  I'm new to this software so please bare with me.
I have tried to install the gtrackbar as stated above and it seems to have installed and I can configure a slider (trackbar) on the form however there is no option for PLC coms in the property section.  Am I missing something?
All other AdvancedHMI components include a PLC Communications option.

Please help