Hi all! I'm new to this software so please bare with me.
I have tried to install the gtrackbar as stated in an older post and it seems to have installed and I can configure a slider (trackbar) on the form however there is no option for PLC coms in the property section. Am I missing something?
All other AdvancedHMI components include a PLC Communications option.
My goal is to be able to use this rather than operator entry for a 0-100% motor speed setting. I know I can always use an up/down button setup but I feel this is sloppy and the slider seems to work well... I just can't set it up to talk to my PLC.
Also noteworthy is that other components built in to AdvancedHMI work fine and communicate very well.
Please help
