Show Posts
1
Support Questions / No response from PLC during write.
« on: September 29, 2016, 11:03:58 PM »
Hi,
I was just trying to get AdvancedHMI working with both my SLC-500 and MicroLogix 1200 today and unable to get AdvancedHMI to communicate with either PLC. I receive the message, ' Exception thrown: 'MfgControl.AdvancedHMI.Drivers.Common.PLCDriverException' in MfgControl.AdvancedHMI.Drivers.dll ' in Visual Studio Community 2015. I am trying to communicate through the SerialDF1forSLCMicroCom driver using AdvancedHMI version 3.99r. All the settings for the driver are configured identical to RSLinx and as such, I am unsure of where to go to from here. I, at the moment am trying to use the Momentary Button Control with the PLC input address under PLCAddressClick but with no avail.
Reading through other posts, I haven't found much information on this particular issue but that my Prolific USB to Serial adapter may be the issue; I am still unsure of that because it has worked very reliably since I purchased it.
Thank you,
Weston Miller
I was just trying to get AdvancedHMI working with both my SLC-500 and MicroLogix 1200 today and unable to get AdvancedHMI to communicate with either PLC. I receive the message, ' Exception thrown: 'MfgControl.AdvancedHMI.Drivers.Common.PLCDriverException' in MfgControl.AdvancedHMI.Drivers.dll ' in Visual Studio Community 2015. I am trying to communicate through the SerialDF1forSLCMicroCom driver using AdvancedHMI version 3.99r. All the settings for the driver are configured identical to RSLinx and as such, I am unsure of where to go to from here. I, at the moment am trying to use the Momentary Button Control with the PLC input address under PLCAddressClick but with no avail.
Reading through other posts, I haven't found much information on this particular issue but that my Prolific USB to Serial adapter may be the issue; I am still unsure of that because it has worked very reliably since I purchased it.
Thank you,
Weston Miller