Show Posts
1
Support Questions / CLX 5000 Eth routing
« on: February 22, 2018, 08:56:29 AM »
So I am trying to route through a ControlLogix chassis to a CompactLogix and I am running in to trouble. Trying to get to internal PLC from outside network.
Setup looks like this:
Bridge chassis
Outside ENBT slot 5 10.60.88.154
Internal ENBT slot 4 192.168.1.1
Target PLC 192.168.1.71
I have tried using various version of the RoutePath with the following results
1, 4, 2, 192.168.1.71, 1, 0 No Response from PLC 10.60.88.154, slot=0
1, 4, 2, 192.168.1.71, 1, 1 No Response from PLC 10.60.88.154, slot=0
1, 4, 2, 192.168.1.71 No Response from PLC 10.60.88.154, slot=0
1,4,2,192.168.1.71 Path Segment Error (Invalid Tag Name)
I am using a MSG on this host PLC using the same route and it works fine. I know with CompactLogix you don't use the routing to the backplane and the PLC slot. Am I missing something obvious? Thanks in advance.
Setup looks like this:
Bridge chassis
Outside ENBT slot 5 10.60.88.154
Internal ENBT slot 4 192.168.1.1
Target PLC 192.168.1.71
I have tried using various version of the RoutePath with the following results
1, 4, 2, 192.168.1.71, 1, 0 No Response from PLC 10.60.88.154, slot=0
1, 4, 2, 192.168.1.71, 1, 1 No Response from PLC 10.60.88.154, slot=0
1, 4, 2, 192.168.1.71 No Response from PLC 10.60.88.154, slot=0
1,4,2,192.168.1.71 Path Segment Error (Invalid Tag Name)
I am using a MSG on this host PLC using the same route and it works fine. I know with CompactLogix you don't use the routing to the backplane and the PLC slot. Am I missing something obvious? Thanks in advance.