Messages

1

Open Discussion / Re: Using Advanced HMI with Allen-Bradley Micrologix 1000 with Serial Cable

« on: September 27, 2019, 11:00:09 PM »

Would that be SerialDF1forSLCMicroCom4?

Because I still cant get it working. Thanks

2

Open Discussion / Using Advanced HMI with Allen-Bradley Micrologix 1000 with Serial Cable

« on: September 27, 2019, 08:28:48 PM »

Hi,

I'm looking to connect to my micrologix 1000 by a serial cable. Just checking which driver I should be using? Using Com4

Cheers Chris

3

Open Discussion / Re: Using AdvancedHmi on Micrologix 1000

« on: June 23, 2018, 07:23:31 PM »

Hi, I tried that today and its working now. I'm sure I tried that before. Thanks, finally got it working.

4

Open Discussion / Re: Using AdvancedHmi on Micrologix 1000

« on: June 22, 2018, 02:22:37 AM »

Thanks for help. I'm still having trouble getting the AHMI to work. I'm using a Micrologix 1000 connected to my computer using a serial cable on com port 3. I know the cable is working as I can view ladder logic on RSlogic micro starter lite and run plc in remote run. Forcing on inputs and outputs.

I just can't get the AVHI to turn on inputs and read outputs. It just seems like its not connecting.

Driver : DF1com3
PLCAddressClicK : B3:0/0
SquareIlluminatedButton1
BaudRate: 9600
ComPort: COM3

Is there something obvious I'm doing wrong?

5

Open Discussion / Re: Using AdvancedHmi on Micrologix 1000

« on: June 21, 2018, 02:08:51 PM »

Yes I’m using Serial. What are the internals? What would B3 or N7 relate to? For example do I label B3 on input I:0.0/0 on RSlogix. Then copy B3 to the plc address value on AHMI? Really appreciate you’re help. Thanks

6

Open Discussion / Using AdvancedHmi on Micrologix 1000

« on: June 21, 2018, 12:12:41 AM »

I'm having trouble when I Start the project on the HMI it says “no response from PLC” what does the plc address relate too? On my Allan Bradley micrologx 1000 the inputs and outputs are I:0.0/0 and O:0.0/2. what does the address you use relate to? I'm trying to turn a input on using a momentary button.

Do I have the correct driver?

What does PLC address relate too?

Is there a way to know the plc is talking to the AvancedHMI?

Is there a guide to do this?