Messages

46

Support Questions / Re: CLXEthernet Driver trouble

« on: August 26, 2013, 04:51:05 PM »

If my computer is set to obtain IP automatically and I give them ethernet card an IP of 192.168.1.1 on private network and set my drivers properties to 192.168.1.1 or 192.168.1.2 it says could not connect to IP addres 192.168.1.1

If my computer is set to obtain IP automatically and I give them ethernet card an IP of 10.12.19.29 on a public network and set my drivers properties to 10.12.19.29 or 10.12.19.126 it says could not connect to IP addres 10.12.19.29 or 10.12.19.126.

If I give my computer IP of 10.12.19.126 with a subnet mask 255.255.255.0 and set ethernet card to public network with IP 10.12.19.29 and set my drivers properties to 10.12.19.29  it says could not connect to 10.12.19.29.

47

Support Questions / Re: CLXEthernet Driver trouble

« on: August 24, 2013, 12:35:22 AM »

Yes

48

Support Questions / CLXEthernet Driver trouble

« on: August 23, 2013, 08:05:22 PM »

Hi I'm trying to use the Ethernet Driver on VB2010 version 3.57 and using a 1756-ENBT A Ethernet card with an L61 cpu.

I just can't seem to communicate. I've tried Setting my own IP address on my computer to (10.12.19.126) with a subnet mask (255.255.255.0) when the the card is configured with IP address (10.12.19.29). Because thats how I connect my rs5000 program to the card normally to download/program. But when I put in hmi properties IP (10.12.19.29) it doesnt work.

Ive also tried configuring the card to a private network with IP (192.168.1.1) and it still doesn't work on HMI program.

What are the correct settings on HMI and my computer for this driver to communicate?

49

Support Questions / Re: Communication Problem

« on: August 20, 2013, 04:16:43 PM »

That did the trick. Thank you! I was really riding the struggle bus on that one.

50

Support Questions / Communication Problem

« on: August 20, 2013, 01:03:02 PM »

I'm New to this AdvancedHMI. My first program was for a SLC using a simple timer preset and accumulation digitmal panel meter. My next program was in a Controllogix just turning on a pilot light with ON/OFF buttons. For both of these programs I have been using the DF1 driver.

Heres my problem. After anywhere from 15 seconds to 5 minutes. I get an error on both the timer program and on the pilot light program saying "Index was outside of the bounds of the array." up untill this happens my program always works fine though. So what do I do about this?

On a side note I am using version 3.5 with Visual Studio 2010.