AdvancedHMI Software
General Category => Support Questions => Topic started by: Intelect on March 09, 2013, 12:21:43 AM
-
Hi
I've had a quick read through the PLC.net forum and haven't found this issue covered.
When openning Advanced HMI all I'm getting is a Black screen.
I'll also note I'm inexperienced when I comes to Visual Studio
Cheers Jason
-
Are you able to build the solution and get items in the Toolbox?
-
I was following the "Quick Start" steps and problem is at step 6 Build Advanced HMI
After building the Advanced HMI solution file all i get is a New window with AdvanceHMI at the top the window is full screen and black.
Thanks for the reply I'm just trying to have a play and see whats out there.
Cheers
-
All good just Noob fault all sorted now thanks for your time
-
Intelect, you should share your solution with the forum just in case other users run into the same problem.
-
Basically the Toolbox wasn't open when I open the solution file and didn't realise it was a Visual Studio window was expecting to open when I Build the solution like I said to Newbe issue. And the black screen was me actually running the HMI program with nothing on the window.