1
Support Questions / Modbus RTU questions
« on: February 28, 2021, 06:35:36 AM »
I use Modbus RTU driver to connect to a Modbus slave.
The addressing scheme of the slave is 0 based so in order to read HR 400050 I have to put the address 400051 in basic label.
Is it possible to setup the AHMI driver to be 0 based as well?
The method modbusRTUCom1.CloseConnection() can be used to close the connection.
How can I reopen it?
The addressing scheme of the slave is 0 based so in order to read HR 400050 I have to put the address 400051 in basic label.
Is it possible to setup the AHMI driver to be 0 based as well?
The method modbusRTUCom1.CloseConnection() can be used to close the connection.
How can I reopen it?