Messages

1

Feature Request / Re: What ....no EZPLC?

« on: May 29, 2018, 04:48:47 PM »

How much cheaper is EZ than Automation Direct? I've never used EZ, but have used AD a few times. Surely you can't save that much.

I have tried them a couple times. I will not use them, they was at one time a vendor for some of AutomationDirect's product line.

2

Support Questions / Another newbie problem?

« on: October 24, 2016, 08:54:55 PM »

 keep getting this error from time to time using the Change Form Buttons??
I'm sure it's me?

3

Support Questions / Re: Driver Error

« on: October 10, 2016, 05:44:15 PM »

Thank you, that is right on point. I am reading these with code.

4

Support Questions / Driver Error

« on: October 10, 2016, 01:50:33 PM »

Ever so often I get this error? I'm sure it's something I'm doing wrong.

5

Open Discussion / Re: Newbie Question

« on: September 25, 2016, 08:30:40 PM »

Thanks, I will try that. How to do a Write to a address? I'm slow but will pick up. I'm doing a shower water on between x time to y time, got that working but need to write a bit to the plc during this time. How do you put up with us newbies???

6

Open Discussion / Re: Newbie Question

« on: September 25, 2016, 06:48:23 PM »

I was having a hard time changing text on the Basic Button depending on On/Off status. This made it easy or more like I know?? I was trying to change the text if the HighLight bit was on or off.
Maybe even an easier way but this works. Thanks for all the hep. I have used everything from Wonderware, Infilink, CX Supervisor, Indusoft, NI Lookout, but I'm liking this. Working on a water control system for jail showers and toilets LOL. 

7

Open Discussion / Re: Newbie Question

« on: September 25, 2016, 06:15:11 PM »

Thanks. I'm too use to off the shelf HMIs and don't have very much time with VB, but I'm learning.

8

Open Discussion / Re: Newbie Question

« on: September 25, 2016, 05:53:59 PM »

Modbus TCP

9

Open Discussion / Newbie Question

« on: September 25, 2016, 05:49:18 PM »

Liking this software so far. I have a simple question. What is the best way to read a SINGLE BIT in to a variable and not an object??