Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - CarlosGranados

Pages: [1]
1
Support Questions / Re: Previous Version AdvancedHmi
« on: January 26, 2018, 07:18:26 PM »
i´ll try, thank you.

2
Support Questions / Previous Version AdvancedHmi
« on: January 26, 2018, 10:15:06 AM »
Hi all

It is possible to get a previous version of the software?
im having problems with the V 3.99, when i try to read an input signal, all indicators with address  of inputs starts flashing, so im looking for a previous version, hoping no to find the same problem

so, can someone please, provide me an older version?

thank you.

3
Support Questions / Pilot Lights Problems
« on: January 20, 2018, 02:55:25 PM »
Hi Guys!

Im using Pilots Lights with diferents PLCAdressValue (I:0/0,I:0/1,I:0/2, Etc) but when i run the program and i activate an input, every lamp start flashing with green color.

do you know whats going on?

EDIT*
The same problem happens with the basic labels, if i use adress of inputs (I:0/0,I:0/1,I:0/2, Etc), when i activate any input, the labels appear and disappear every halfsecond.


4
Support Questions / Re: Advanced HMI with Micrologix 1400
« on: January 20, 2018, 09:33:12 AM »
Its Works Fine, Thank you a lot :)


5
Support Questions / Advanced HMI with Micrologix 1400
« on: January 19, 2018, 06:31:31 PM »
Hi Everyone, i want to create an interface between a Micrologix1400 and AdvancedHmi v3.99X
i have a problem with it.
 following the instructions 1)-6) in order to link rslogix500 and AdvancedHmi
Im unsig the ip on plc 192.168.0.10
on ethernetIPforCLXCom1 is the same
im using on my computer 192.168.0.xxx, can link good the plc and the pc.
so, im using a digitalpanelmeter with PLCAddressValue N7:0
when i start the program with VS15, but its appears the message "Path destination unknow"
can some one please can tellme, whats going on?
thank you su much for your attention.

Pages: [1]