AdvancedHMI Software
General Category => Support Questions => Topic started by: usapatriotforlife on August 21, 2013, 03:10:04 AM
-
It could be just me and my development platform, but I'm experiencing the following issue with v356: I can take a brand new solution directly from the website, add a panelmeter and and an EthernetIPforPLCSLCMicroCom1 driver. Set the PLC Address value and the IP address in the control, build and run and my cpu goes to about 40% and stays their as long as the program is running. If I add a couple of these drivers, the CPU pegs at 100%. Also, data doesn't seem to read in as snappy in this release.
I tried the identical setting with a version 341 of AHMI and the cpu barely budged on my computer.
I get the same results copying the files out and running them on a different workstation from my dev computer as well.
Any ideas on what to try to fix this? Thanks!
-
I found a problem with the driver thread that causes high CPU usage. I fixed the problem and it made my usage drop from 12% to 0%. I'll post an update this evening.
-
You are amazing, I don't see how you manage to do all of this. Thank you so much.
-
Ver 3.57 is now posted that should resolve the high CPU issue.
-
3.5.7 tested and confirmed to definitely fix the CPU utilization and sluggishness issue reported in this thread. AWESOME!! :) Thank you so much.