General Category > Support Questions
RE: Make Global Object
zach_a_ary:
On the original post "Make Global object" by Tazmahal, I got up to step 10 of Archies instructions but "GroupObject"
was not in my toolbox. I tried putting the downloaded file under "Controls" and then it did pop up in my toolbox but it wouldnt let me drag it down to my form. Any ideas?
Archie:
If you Build the Solution, do you get any errors?
zach_a_ary:
No and i managed to get it to pop up finally. However i still cant get it to work. i have a data type called PE. Lets just say the name was "PE1". i have several submembers such as:
.I bool
.Blk bool
.Clr bool
.BlkCTU CTU
.Name String
etc.
under the Grouped object file, i put a basic indicator. Under PLCAddressSelectColor2 I put ".Blk"
then when i drug a grouped object to my form, under "PLCAddressUDT" i put "PE1". I made sure
the ethernet address was right and it still wont work. If i had color #2 set to green, the basic indicator
just stays green
Archie:
The IPAddress you checked, was that in the editing of the GroupedObject? Do you get an error in the BasicLabel on the grouped object?
zach_a_ary:
i deleted the basic label and added the basic indicator. Here are some screenshots I took. I might have missed a step somewhere. 192.168.70.10 is the ip i need.
Navigation
[0] Message Index
[#] Next page
Go to full version