General Category > Support Questions
Null Reference Exception
(1/1)
Kasky:
I'm using the Modbus/TCP comm driver and with just a simple panel meter for the application.
I am able to read a single memory location and display it's changing value in the panel meter for approximately 10 seconds or so then I get the Null Reference Exception.
Is this a known issue? Any suggestions on what I might try?
Thank you
Archie:
Check post 681 here:
http://www.plctalk.net/qanda/showthread.php?t=42656&highlight=driver+patch&page=46
Kasky:
Thank you!
Worked like a charm and I very much appreciate the quick response!
Kasky:
With page 2 already created I tried placing a new control (DigitalPanelMeter) on page two and addressing it to a known working address and got nothing.
The I placed a new Modbus/TCP control on page two, set it up identical to the one already on the main page except for the name of course and now I get the same NullReferenceException I was getting before I applied the patch. The error only happens when I go to page 2.
Thank you
Navigation
[0] Message Index
Go to full version