AdvancedHMI Software
General Category => Support Questions => Topic started by: scott.clark on October 30, 2015, 07:35:41 PM
-
Using AdvancedHMI 3.99a
I am having an issue hiding the a FormChangeButton using the PLCAddressVisible property.
I have a Bool type variable in the PLCAddressVisible property and have selected the CommComponent EthernetIPforCLXCom1. but the state of the PLCAddress has no effect.
I know the PLC address I am using is good, tested it with the PLCAddressVisible property for a BasicButton. Any ideas?
-
I can't believe that slipped through so long without getting reported.
Add this code to FormChangeButton.vb
Protected Overrides Sub OnHandleCreated(e As EventArgs)
MyBase.OnHandleCreated(e)
SubscribeToCommDriver()
End Sub
Then make sure ComComponent property is set
-
Works like a charm!