AdvancedHMI Software
General Category => Support Questions => Topic started by: oqapsking on August 08, 2019, 11:30:11 AM
-
hello
in advancedhmi we can use the ini file to write the plc ip address in it and then the advancedhmi read them .
what i need is to make a new form that from it i can modify the addresses and show them
and when i modify them the update in the advancedhmi instead of turning of the software and modify them by notepad then save the file and start the software again
can anyone help me
with thanks
-
I'm too busy to be of much help, but if you still have one of my demo apps it does INI read and write, that's what I used for app config.
-
Ok i will look at it
Thanks for responding