Topics

1

Support Questions / basic trend chart not graphing

« on: May 21, 2016, 04:12:52 PM »

I am trying to get the basic trend chart to graph the temperature change on my solo temp controller...... I have it set up properly with the addresses needed and high and low is also set properly within temp range but the trend chart doesn't graph anything at all....even if I download the advanced hmi/solo project and run it nothing is graphed..everything else works but the graph

2

Support Questions / advanced hmi doesn't run ones built

« on: May 21, 2016, 02:00:16 PM »

I am having issues with my advanced hmi buids.......my advanced hmi project works great when I run in it visual studios but when I switch to release and click build advanced hmi and then go into the release folder and try running the exe file nothing opens up.......what could cause this issue? thanks

3

Support Questions / more than one page

« on: May 19, 2016, 04:57:09 PM »

I for the life of me can't figure out how to have more than one page with advanced hmi.... Like one page for conrols another for alarms and so on.......and how to cycle from one to the other? thanks

4

Support Questions / Advanced HMI with Solo Pid Controller from automation direct

« on: May 13, 2016, 05:16:52 PM »

Hi, I am new so advanced hmi but I have been fiddling around with it quite a bit and have been very impressed and yes frustrated.... I have gotten the communication with my solo pid controller working perfectly with the Modbus rtu driver... I have read/write access to my Temperature setting value ( so I can set the temp I want) and have read access to the PV or present temperature value
I can also set the power output if running in manual instead of PID (with some issues that I will elaborate on)   
I have done all this using the digital panel meters......worked great but for power output I wanted a vertical slider instead...so I purchased the add on pack..... configured everything and it worked, well sort off..... when I set slider to 100 it only goes to 10 on solo controller (pid has one decimal place so on pid it is 10.0)....
 well I figured this was an easy just change value scale factor under the vertical slider properties..... now this did indeed get my numbers to be the same but now I can only drag the slider up to 10 instead of all the way up to 100.... please help me out...

I also have other issues with communication to certain parameters......... I will attach a screenshot of the addresses that advanced hmi gives me an error on... says address can not start with that number... any help is appreciated thanks