Messages

1

Open Discussion / Web status report question

« on: April 07, 2017, 05:25:43 PM »

Hello,

I am looking to generate a "web status report."  Basically I just want a text listing of 50 or so parameters put into an HTML file and automatically uploaded via FTP to a website. 

I see tons of discussion and requests for web enabling AdvancedHMI but that is beyond what I need right now.

Has anyone done something like this? 

2

Support Questions / Re: Only one meter at a time works

« on: April 03, 2017, 02:04:11 PM »

I switched from Floating Point numbers to unsigned integers and I think it is working now.  I will restart it a few dozen times and try to report back.

Thanks

3

Support Questions / Re: Only one meter at a time works

« on: April 03, 2017, 11:14:13 AM »

Strangely the problem is intermittent.  If I use the pc to simulate the modbus values I get similar results.  The meters only work intermittently, some of them seem to be more problematic than others.  I just ran the program 15 times.  One meter didn't work 5 of those times, another didn't work 6 of them, the other 9 were reliable.

This behavior sounds a bit different from what I described in the original post.  I was not polling data for all 11 meters last night so it looked a little different to me.

4

Support Questions / Only one meter at a time works

« on: April 02, 2017, 09:18:24 PM »

Hello,
I have been experimenting with AdvancedHMI for the last couple of hours.  I am polling a DL06 PLC and trying to display 9 analog meters and 2 bar meters on a single page.  For some reason only one of the meters will work at a time.  Every time I re-run the application a different one will work.  The modbus tcp polling is set for 100ms
and I am using floating point numbers.  Can anyone offer some advice?