Messages

16

Open Discussion / Re: Omron FINS UDP port

« on: May 23, 2018, 12:43:03 PM »

I have many Omron PLCs and each uses a different port number.  I'm able to change the port number, per your instruction on my earlier post, and it works well until I found out that each PLC uses a different port.

Any suggestion of a work around?

17

Open Discussion / Omron FINS UDP port

« on: May 22, 2018, 07:15:20 PM »

Is there a way to assign/change UDP port number programmatically during run time?

18

Open Discussion / Re: Omron CJ2M FINS

« on: September 26, 2017, 04:42:37 PM »

Thanks Archie, works great.

19

Open Discussion / Omron CJ2M FINS

« on: September 22, 2017, 04:20:16 PM »

What is the default UDP port no of the omronEthernetFINSCom?  How can I change the port no?

20

Support Questions / Re: Modbus rtu

« on: July 10, 2017, 04:22:11 PM »

Using the AdvanceHMIcs runs without error.

What would be the different??

21

Support Questions / Modbus rtu

« on: July 10, 2017, 03:48:40 PM »

I am new to this and am trying out.
I added a new project to AdvanceHMIv35 solution, set it as default  and on a blank form I add a modbusRTUCom1, it passes build but when I run it, it gives an error below :

System.Exception occurred
  HResult=0x80131500
  Message=Missing Components from AdvancedHMI. C:\Users\mfgLoadmin\Documents\Visual Studio 2017\Projects\AdvancedHMIv399w\HMI_1\bin\Debug\ - Please refer to the licensing agreement.
  Source=MfgControl.AdvancedHMI.Drivers

I'm using VS2017 community edition in C#.  Any help please!