« previous next »
Pages: [1]

Author Topic: Cannot communicate to OMRON CJ2M  (Read 903 times)

frenelius

  • Newbie
  • *
  • Posts: 7
    • View Profile
Cannot communicate to OMRON CJ2M
« on: March 31, 2021, 02:13:49 AM »
Hello,
I am testing HMI to see if I can replace the NB displays, but I cannot get to have full communication with the PLC through OmronEthernetFINSCom.

PLC CJ2M-CPU31

In some cases, I can write to D0, but will not get a valid response back from the PLC. And I have not been able to read D0 never.

Attached the Wireshark capture. PLC address is 10.0.0.1, AHMI is 10.0.0.5.

Do anybody know if it is just a configuration problem?

I have been trying different options (TargetNetworkAddress, TargetNodeAddress, Private, Public...) without luck.

Thanks a lot!
Logged

Archie

  • Administrator
  • Hero Member
  • *****
  • Posts: 5270
    • View Profile
    • AdvancedHMI
Re: Cannot communicate to OMRON CJ2M
« Reply #1 on: March 31, 2021, 03:39:37 AM »
According to the error code being received 0x0502

 "Relaying is not possible because there are no routing tables"
Logged

frenelius

  • Newbie
  • *
  • Posts: 7
    • View Profile
Re: Cannot communicate to OMRON CJ2M
« Reply #2 on: March 31, 2021, 03:53:17 AM »
But the error I see in Wireshark is 0x8502, is it the same as 0x0502?

Thanks.
Logged

Archie

  • Administrator
  • Hero Member
  • *****
  • Posts: 5270
    • View Profile
    • AdvancedHMI
Re: Cannot communicate to OMRON CJ2M
« Reply #3 on: March 31, 2021, 04:19:41 AM »
The 8 indicates a network relay error
Logged

Archie

  • Administrator
  • Hero Member
  • *****
  • Posts: 5270
    • View Profile
    • AdvancedHMI
Re: Cannot communicate to OMRON CJ2M
« Reply #4 on: March 31, 2021, 04:22:13 AM »
Attached is more specific information
Logged
Pages: [1]
« previous next »