31
Support Questions / Re: How to place a form on top of the mainform
« on: September 08, 2018, 01:59:07 PM »
Hi Archie
Thanks, I got it working.
/Holmux
Thanks, I got it working.
/Holmux
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
32
Support Questions / Re: How to place a form on top of the mainform
« on: September 08, 2018, 11:43:14 AM »
I have looked into this as well, but being a newbie I am struggling with a simple thing like calling the child form with a button, if I use the MainMenuButton, I can't choose
the childform from the list, but it would work if I just figure out haw to call them without using the menu.
the childform from the list, but it would work if I just figure out haw to call them without using the menu.
33
Support Questions / Re: How to place a form on top of the mainform
« on: September 08, 2018, 11:07:05 AM »
Thanks Archie
I have tried going that route as well, just place the menu in the bottom and the forms on top, I would have like to have the menu in full size and the forms on top
but I haven't worked out how to place anything over parts of the menu, is this possible ?
I would like to leave stuff like Exit buttons and out system setup variables on the menu behind the forms, so when I close the forms I am left with system setup.
This is just how I would normally do this in the SCADA systems I use to work with, maybe this is not the right approach in Visual and I need to take another route.
/Holmux
I have tried going that route as well, just place the menu in the bottom and the forms on top, I would have like to have the menu in full size and the forms on top
but I haven't worked out how to place anything over parts of the menu, is this possible ?
I would like to leave stuff like Exit buttons and out system setup variables on the menu behind the forms, so when I close the forms I am left with system setup.
This is just how I would normally do this in the SCADA systems I use to work with, maybe this is not the right approach in Visual and I need to take another route.
/Holmux
34
Support Questions / How to place a form on top of the mainform
« on: September 08, 2018, 09:18:42 AM »
Dear Forum
I am very new to the AdvancedHMI setup and Visual for that matter, so this newbie level questions
My plan was to use the mainform and place a row of 7 buttons in the bottom of the form, from these
buttons I would like to call forms that will lay on top of the mainform, all the forms I call will be shorter
then the mainform, so the buttons always are visable.
But when I call a form on top, it is positioned to the left of the mainform, how do i change this so they are
positioned from the left top corner of the mainform ??
I have tried all combinations in the layout section but haven't found the solution,
Please advice
/Holmux
I am very new to the AdvancedHMI setup and Visual for that matter, so this newbie level questions
My plan was to use the mainform and place a row of 7 buttons in the bottom of the form, from these
buttons I would like to call forms that will lay on top of the mainform, all the forms I call will be shorter
then the mainform, so the buttons always are visable.
But when I call a form on top, it is positioned to the left of the mainform, how do i change this so they are
positioned from the left top corner of the mainform ??
I have tried all combinations in the layout section but haven't found the solution,
Please advice
/Holmux