AdvancedHMI Software

General Category => Support Questions => Topic started by: MrPike on April 26, 2015, 10:30:45 PM

Title: OPC Help
Post by: MrPike on April 26, 2015, 10:30:45 PM

Archie Im trying to connect to a device with OPC.  Im very new to using OPC.  Does the AHMI driver only support connection thru serial Com port1 or can TCP be used?  I attached a screenshot of the connection that I have connected to the device.  What would be the proper way to enter the info into the AHMI OpcDACom1 driver and a basic label?  Thx   

Title: Re: OPC Help
Post by: Archie on April 26, 2015, 11:08:56 PM

OPC can sometimes be a pain trying to figure out how to set it up because every server is different. Based on your screenshot, this is what I would try:

In OpcDaCom1, set OPCServer to SWToolBox.OmniServer
Add a BasicLabel and set PLCAddressValue to g1pm.normab