Messages

1

Open Discussion / Re: Trackbar question

« on: September 03, 2016, 01:55:28 PM »

Wow! Thank you for the fast response Archie!! Appreciate that so much!

I have purchase and installed the controls. That part works now.

However, I am using this with a GE Fanuc and I now noticed and read that the SNP driver is no longer included because of some issues.

So, is V3.5 still available (and where) that I see was the last version that included the SNP driver.

Also, will the new Analog controls work with V3.5?

Appreciate comments on this.

2

Open Discussion / Trackbar question

« on: September 03, 2016, 09:41:22 AM »

I am needing to read a Trackbar value and then write that value to a digital display on the screen.
I think that I need to output the value of the Trackbar to a register. Then in the PLC program move that value to the register value assigned to the digital display. Something along that line.

However, I do not see any PLC address in the properties of the Trackbar where I can assign a register value.

It should not be that difficult. Is there something that I am missing here.

Appreciate any comments on this. I am under the gun to get this project done this weekend.