Author Topic: Saving Multiple HMI Programs to ONE computer  (Read 1911 times)

Programmer81

  • Newbie
  • *
  • Posts: 1
    • View Profile
Saving Multiple HMI Programs to ONE computer
« on: May 20, 2014, 12:48:09 PM »
I have run into an issue.  I cannot seem to save and run multiple HMI programs to one computer.  Has anyone else run into this problem?  I have no issue creating an executable, but I can't have multiple executable files done in AdvancedHMI and run them on the same computer.  My issue is that I'm actually trending data from this software and saving to a CSV file on my server.  I would like to run multiple programs I write in this wonderful piece of software on one computer. 

Any advice?

dmroeder

  • Administrator
  • Full Member
  • *****
  • Posts: 211
    • View Profile
Re: Saving Multiple HMI Programs to ONE computer
« Reply #1 on: May 20, 2014, 02:02:16 PM »
I think "make single instance" is checked by default which would only allow you to run one instance at a time.  Try un-checking it:

Go to Project > AdvancedHMI Properties > Uncheck "Make single instance application".